J2101A-J2101A-深圳市迪福伦斯科技有限公司手机版

开关电源环路稳定性测试配套的隔离变压器，增益相位测试
10Hz supports off-line power supplies
45MHz high enough for even state of the art regulators
23 Octave range
Low distortion for superior precision
5 Ohm termination for minimum impact to loop
Includes attenuation to assure small signal measurement

Performance at -10dBm input level
Characteristic		Rating
DCR
Ratio		1:1
Termination Impedance		5 Ohms
* Nominal 3dB Bandwidth		10Hz - 45MHz (Terminated into 5 Ohms) 60Hz - 45MHz (Terminated into 50 Ohms)
Isolation Voltage		600V
Isolation Capacitance		150pF
DC current		10mA
Temperature range		0-50C
Maximum Altitude		6000 Ft

10Hz supports off-line power supplies
45MHz high enough for even state of the art regulators
23 Octave range
Low distortion for superior precision
5 Ohm termination for minimum impact to loop
Includes attenuation to assure small signal measurement

The injection transformer is presently the prevalent method for connecting the network analyzer to the circuit being tested, and is primarily used for control loop stability measurements. The goal of the transformer is to inject a signal into the control loop being measured, without impacting the performance of the loop. In order to accomplish this to a reasonable degree, The transformer is isolated and therefore is capable of floating on a high voltage, such as a Power Factor Corrector (PFC), which is often close to 400VDC. Measuring voltages that exceed the voltage rating of the Bode-100 inputs require attenuation probes.

The usable bandwidth of an injection transformer is generally significantly greater than the 3dB frequency limits. This is because the transformer itself is outside of the measurement, leading many to incorrectly believe that the transformer is a non-critical element.

The bandwidth of the transformer is strongly related to the terminating impedance. The Bode-100, and most network analyzers, provide a 50 Ohm oscillator source impedance. Assuming this impedance the optimal termination resistor is 5 Ohms. This significantly attenuates the injection signal, which is generally beneficial, as a common error in Bode measurements is using a signal which is too large, and therefore not a small signal measurement. An added benefit of this low value is that it can generally be left in circuit at all times, simplifying the connection to the network analyzer without appreciably impacting the output voltage of the circuit being tested.

J2101A：測試訊號轉換器，隔离变压器10Hz-45MHz

产品简介

详细介绍